Get Cozy - More Savings! ~ Up to 60% OFF ~ Tax FREE ~ Nationwide Next Day Shipping ~ Now FINANCING!

PDP - Lock Compatibility - Air Series

Weslock Elegance - Attebery

Compatible with Air 4, Air 5, & Air Lite

BORE HOLE - LOCK SPEC

If you choose to purchase your hardware/lockset from a third party vendor, please make sure to provide them with the following specifications to ensure that your desired lockset will be compatible with our doors.

 Bore hole size:
2 1/8”
Back set:
2 3/4”
Center to center:
5 1/2”
Door thickness: 2"

  

  • In stock single doors come with two pre drilled bore holes (one active lock needed) unless if otherwise specified.
  • In stock double doors come with two pre drilled bore holes on each door (one active lock and one dummy lock needed) unless if otherwise specified.
  • Locks purchased from Pinky’s Iron Doors do not come installed on door upon delivery or shipment.  The reason for this is that it may get damage during the delivery or shipment process.  The installer will need to install the lock after the door installation is complete.

 

Bore Hole: 

A bore hole is the doorknob hole  that is drilled on the face of the door with a hole saw.  The hole is drilled halfway through from each side.  The hole saw is also used to drill the cross bore otherwise known as the latch hole.  Both doorknob hole and latch holes come completed and drilled with every in stock order to help your installer install the lock at ease.

 

Center to Center:

The vertical distance measured between the center-points of the two bore holes.  In other words, it is the measurement from the middle of the top bore hole to the middle of the bottom bore hole.  This measurement is used to determine where a bore for the deadbolt is located above the bore for the latch.  This information is important to help our customers purchase the correct compatible lock if you choose to purchase them from an outside hardware store.  We have already done the homework for you by specifying the Pinky’s locks that are compatible with your door if you choose to purchase the locks from Pinky’s Iron Doors.

 

​​​

Back Set:

The backset is the distance from the edge of the door to the center of the 2-1/8” bore hole.  The back set measurement is important to help our customers purchase the correct compatible lock with the correct latch size.  We have already done the homework for you by specifying the Pinky’s locks that are compatible with your door if you choose to purchase the locks from Pinky’s Iron Doors.  Our customers do not have to purchase the locks from Pinky’s, you may purchase the locks from any local hardware store of your liking.

 

Door Thickness